Toyota Venza: Fail-safe Chart

Toyota Venza Service Manual / Cruise Control / Cruise Control System / Fail-safe Chart

FAIL-SAFE CHART

HINT:

If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition	Auto Cancel Condition	Re-operation Condition
CRUISE main indicator light blinks	There is an open or short in the stop light switch assembly circuit There is a problem with the vehicle speed signal	Turn cruise control main switch on again
CRUISE main indicator light blinks	There is a problem with the input circuit of the stop light switch assembly There is a problem with the cancel circuit	Turn ignition switch off then on again Turn cruise control main switch on again
CRUISE main indicator light goes off	There is a problem with the throttle position sensor and motor (throttle with motor body assembly)	Turn cruise control main switch on again
CRUISE main indicator light remains on	Under the following conditions, the stored vehicle speed is maintained: Vehicle speed is lower than the low speed limit (approximately 40 km/h (25 mph)) while the vehicle is driven with the cruise control on VSC system operates	Push cruise control main switch to + RES
CRUISE main indicator light remains on	Vehicle speed is lower than the stored speed by approximately 16 km/h (10 mph) or more	Push cruise control main switch to - SET

Dtc Check / Clear

DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Cruise Control / ...

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota Venza:

Precaution
PRECAUTION 1. NOTICE FOR INITIALIZATION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected. System Name See Procedure Back Doo ...

Dtc Check / Clear
DTC CHECK / CLEAR NOTICE: When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame ...

Inspection
INSPECTION PROCEDURE 1. INSPECT PRELOAD (a) Using SST and a torque wrench, measure the preload of the backlash between the driven pinion and ring gear. SST: 09326-20011 Preload (at Starting): Item P ...