Toyota Venza: Exterior Panels / Trim
- Back Door Outside Garnish
- Black Out Tape(for Front Door)
- Black Out Tape(for Rear Door)
- Front Bumper
- Front Door Belt Moulding
- Front Door Window Frame Moulding
- Name Plate
- Radiator Grille
- Rear Bumper
- Rear Door Belt Moulding
- Rear Door Window Frame Moulding
- Rear Spoiler
- Rear Wheel House Plate
- Rocker Panel Moulding
- Roof Drip Side Finish Moulding
- Side Mudguard
Reassembly
REASSEMBLY
PROCEDURE
1. REPAIR INSTRUCTION
2. INSTALL REAR DOOR OUTSIDE MOULDING
3. INSTALL REAR DOOR LOWER OUTSIDE STRIPE
4. INSTALL NO. 2 BLACK OUT TAPE
5. INSTALL REAR DOOR OUTSID ...
Other materials about Toyota Venza:
Transfer Case Front Oil Seal(for Rh Side)
Components
COMPONENTS
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. DRAIN TRANSFER OIL
(a) Remove the transfer drain plug and gasket to drain the transfer oil.
(b) Install a new gasket and the transfer drain plug.
Torque:
49 N·m {500 kgf ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT BLOWER MOTOR SUB-ASSEMBLY
(a) Install the front blower motor sub-assembly with the 3 screws.
2. INSTALL AIR INLET SERVO MOTOR SUB-ASSEMBLY
(a) Insta ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL COOLER CONDENSER ASSEMBLY
(a) Install the cooler condenser assembly with the 4 bolts.
Torque:
6.0 N·m {61 kgf·cm, 53 in·lbf}
HINT:
If the condenser is replaced with a new one, add compressor oil t ...
0.1702