Toyota Venza: Exhaust Pipe

Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 1 MANIFOLD CONVERTER INSULATOR (a) Install the No. 1 manifold converter insulator to the exhaust manifold converter sub-assembly with the 4 bolt ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Center Airbag Sensor Assembly Malfunction (B1000/31)
DESCRIPTION The center airbag sensor assembly consists of a deceleration sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc. If the center airbag sensor assembly receives signals from the deceleration sensor, it determines whe ...

Assist Map Number Un-Writing (C1581)
DESCRIPTION The power steering ECU stores this DTC when it determines that the assist map is not written in the ECU. HINT: The assist map is data written in the power steering ECU to control the degree of assistance. The assist map is selected based on ...

Knock Sensor
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INTAKE MANIFOLD (a) Remove the intake manifold (See page ). 2. REMOVE KNOCK SENSOR (a) Disconnect the sensor connector. ...