DESCRIPTION
The smart key system uses the wireless door lock buzzer to perform various vehicle exterior warnings. When the conditions for each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer request signal to the main body ECU (driver side junction block assembly) via CAN communication. The wireless door lock assembly sounds the buzzer according to the signal from the main body ECU.
CAUTION / NOTICE / HINT
NOTICE:
The smart key system (for entry function) uses a multiplex communication system
(LIN communication system) and CAN communication system. Inspect the communication
function by following How to Proceed with Troubleshooting (See page
). Troubleshoot the smart key system (for entry
function) after confirming that the communication system is functioning properly.
PROCEDURE
1. |
READ VALUE USING TECHSTREAM (ANSWER-BACK BUZZER FUNCTION) |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) Read the Data List according to the display on the Techstream.
Main Body (Main Body ECU (Driver Side Junction Block Assembly))
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|
Wireless Buzzer Resp |
Answer-back buzzer operation / ON or OFF |
Customization status displayed |
- |
Result |
Proceed to |
---|---|
Customize setting is ON. |
A |
Customize setting is OFF. |
B |
B |
PERFORM CUSTOMIZE SETTING (Proceed to Customize Parameters) |
|
2. |
PERFORM ACTIVE TEST USING TECHSTREAM |
(a) Enter the following menus: Body Electrical / Main Body / Active Test.
(b) Perform the Active Test according to the display on the Techstream.
Main Body (Main Body ECU (Driver Side Junction Block Assembly))
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
---|---|---|---|
Wireless Buzzer |
Turns the wireless door lock buzzer |
ON/OFF |
- |
OK:
Wireless door lock buzzer sounds.
OK |
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
NG |
GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (Proceed to No Answer-Back) |
Starter Relay Circuit High (P0617)
MONITOR DESCRIPTION
While the engine is being cranked, battery voltage is applied to terminal STA
of the ECM. If the ECM detects the Starter Control (STA) signal while the vehicle
is being driven, it determines that there is a malfunction in the STA circu ...
Replacing a flat tire
Chock the tires.
Slightly loosen the wheel nuts (one turn).
Turn the tire jack portion “A” by hand until the notch of the jack is in contact
with the jack point.
Raise the vehicle until the tire is slightly raised off the ground.
Remove a ...
Input / Turbine Speed Sensor Circuit Malfunction (P0715,P0717)
DESCRIPTION
This sensor detects the rotation speed of the turbine which shows the input revolution
(speed) of the transaxle. By comparing the input turbine speed signal (NT) with
the counter gear speed sensor signal (NC), the TCM detects the shift timing ...