Toyota Venza: Engine Oil Cooler

Toyota Venza Service Manual / 1ar-fe Lubrication / Engine Oil Cooler

Components

COMPONENTS

ILLUSTRATION

Removal

REMOVAL

PROCEDURE

1. REMOVE EXHAUST MANIFOLD ASSEMBLY

HINT:

See page

2. DRAIN ENGINE OIL

3. DRAIN ENGINE COOLANT

4. REMOVE OIL COOLER ASSEMBLY

(a) Remove the nut, union bolt, seal washer and oil cooler assembly.

(b) Remove the 3 gaskets from the oil cooler assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT ENGINE OIL COOLER

(a) Visually check the engine oil cooler for cracks or damage.

If cracks or damage are found, replace the engine oil cooler.

Installation

INSTALLATION

PROCEDURE

1. INSTALL OIL COOLER ASSEMBLY

(a) Clean the oil cooler contact surface on the cooler mounting.

(b) Apply a light coat of engine oil to 3 new gaskets.

(d) Temporarily install the oil cooler assembly with the union bolt, nut and a new seal washer.

(e) Tighten the bolt and nut in several steps, in the sequence shown in the illustration.

Torque:

Union Bolt :

60 N·m {612 kgf·cm, 44 ft·lbf}

Nut :

10 N·m {102 kgf·cm, 7 ft·lbf}

2. INSTALL EXHAUST MANIFOLD ASSEMBLY

HINT:

See page

3. ADD ENGINE OIL

4. ADD ENGINE COOLANT

5. INSPECT FOR OIL LEAK

6. INSPECT ENGINE OIL LEVEL

Lubrication System

On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ENGINE OIL LEVEL (a) Warm up the engine, stop it and wait 5 minutes. The engine oil level should be between the low level mark ...

Other materials about Toyota Venza:

Power Source Circuit
DESCRIPTION This circuit supplies power source voltage from the battery to terminal B of the steering lock ECU (steering lock actuator assembly). This is used as power source for the CPU, motor, communication, and peripheral circuits. WIRING DIAGRAM P ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column ...

Diagnosis Circuit
DESCRIPTION This circuit is used to read the DTCs that are output from the transponder key ECU assembly with the Techstream. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the transponder key ECU assembly is replaced, register the key and ECU commu ...