With the engine at operating temperature and turned off, check the oil level on the dipstick.
- Checking the engine oil
Park the vehicle on level ground.
After warming up the engine and turning it off, wait more than five minutes for
the oil to drain back into the bottom of the engine.
Hold a rag under the end and pull the dipstick out.
Wipe the dipstick clean.
Reinsert the dipstick fully.
Holding a rag under the end, pull
the dipstick out and check the oil level.
► Flat dipstick
1. Low
2. Normal
3. Excessive
The shape of the dipstick may differ depending on the type of vehicle or engine.
► Non-flat dipstick
1. Low
2. Normal
3. Excessive
The shape of the dipstick may differ depending on the type of vehicle or engine.
Wipe the dipstick and reinsert it
fully.
- Adding engine oil
If the oil level is below or near the low level mark, add engine oil of the same type as already in the engine.
Make sure to check the oil type and prepare the items needed before adding oil.
Remove the oil filler cap.
Add engine oil slowly, checking
the dipstick.
Install the filler cap, turning
it clockwise.
- Engine oil consumption
A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.
• When the engine is new, for example directly after purchasing the vehicle or after replacing the engine • If low quality oil or oil of an inappropriate viscosity is used • When driving at high engine speeds or with a heavy load, when towing, or when driving while accelerating or decelerating frequently • When leaving the engine idling for a long time, or when driving frequently through heavy traffic
CAUTION
- Used engine oil
• Used engine oil contains potentially harmful contaminants which may cause skin disorders such as inflammation or skin cancer, so care should be taken to avoid prolonged and repeated contact. To remove used engine oil from your skin, wash thoroughly with soap and water.
• Dispose of used oil and filters only in a safe and acceptable manner. Do not dispose of used oil and filters in household trash, in sewers or onto the ground.
Call your Toyota dealer, service station or auto parts store for information concerning recycling or disposal.
• Do not leave used engine oil within the reach of children.
NOTICE
- To prevent serious engine damage
Check the oil level on regular basis.
- When replacing the engine oil
• Be careful not to spill engine oil on the vehicle components.
• Avoid overfilling, or the engine could be damaged.
• Check the oil level on the dipstick every time you refill the vehicle.
• Be sure the engine oil filler cap is properly retightened.
Back Door Motor Clutch Malfunction (B2225)
DESCRIPTION
When an electrical malfunction (open or short) is detected in the clutch circuit
of the power back door ECU (power back door motor unit) while the power back door
is operating, the power back door ECU (power back door motor unit) stores DTC B2 ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT DOOR BELT MOULDING
(a) Engage the 5 claws to install the front door belt moulding.
(b) Install the clip.
2. INSTALL FRONT DOOR GLASS RUN
3. INSTALL FRONT ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. PRECAUTION
HINT:
See page
2. DRAIN AUTOMATIC TRANSAXLE FLUID
HINT:
for U ...