- Starting the engine
Check that the parking brake is
set.
Check that the shift lever is set
in “P”.
Sit in the driver’s seat and firmly
depress the brake pedal.
Turn the engine switch to the “START”
position and start the engine.
- Engine (ignition) switch
1. “LOCK”
The steering wheel is locked and the key can be removed.
(The key can be removed only when the shift lever is in “P”.) 2. “ACC” Some electrical components such as the audio system can be used.
3. “ON”
All electrical components can be used.
4. “START”
For starting the engine.
- Turning the key from “ACC” to “LOCK”
Shift the shift lever to “P”.
Push in the key and turn to the
“LOCK” position.
- When the steering lock cannot be released
When starting the engine, the engine switch may seem stuck in the “LOCK” position. To free it, turn the key while turning the steering wheel slightly in either direction.
- If the engine does not start
The engine immobilizer system may not have been deactivated.
- Key reminder function
A buzzer sounds if the driver’s door is opened, while the engine switch is in “LOCK” or “ACC” position to remind you to remove the key.
CAUTION
- When starting the engine
Always start the engine while sitting in the driver’s seat. Do not depress the accelerator pedal while starting the engine under any circumstances.
Doing so may cause an accident resulting in death or serious injury.
- While driving
Do not turn the engine switch to the “LOCK” position.
If in an emergency, you must turn the engine off while the vehicle is moving, turn the key only to the “ACC” position.
NOTICE
- To prevent battery discharge
Do not leave the key in the “ACC” or “ON” position for long periods without the engine running.
- When starting the engine
• Do not crank for more than 30 seconds at a time. This may overheat the starter and wiring systems.
• Do not race the cold engine.
• If the engine becomes difficult to start or stalls frequently, have the engine checked immediately.
Throttle / Pedal Position Sensor / Switch "D" Circuit (P2120,P2122,P2123,P2125,P2127,P2128,P2138)
DESCRIPTION
HINT:
This Electronic Throttle Control System (ETCS) does not use a throttle
cable.
These DTCs relate to the accelerator pedal sensor assembly.
The accelerator pedal sensor assembly is mounted on the accelerator pedal brack ...
Inspection
INSPECTION
CAUTION / NOTICE / HINT
NOTICE:
Ensure that fingers or articles of clothing do not get caught in moving parts
when performing this test.
PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
(a) Check the LO operation.
(1) Conne ...
Front Passenger Side Power Window Auto Up / Down Function does not Operate with
Front Passenger Side Power Window Switch
DESCRIPTION
If the manual up/down function can be performed but the auto up/down function
cannot, the fail-safe mode may be functioning.
If the power window initialization (See page
) has not been performed, the auto up/down function
will not operate.
...