Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT SECURITY COURTESY SWITCH (HOOD LOCK ASSEMBLY)
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the security courtesy switch (hood lock assembly). |
|
Removal
REMOVAL
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
2. REMOVE RADIATOR GRILLE
3. REMOVE HIGH PITCHED HORN ASSEMBLY
4. REMOVE SECURITY COURTESY SWITCH (HOOD LOCK ASSEMBLY)
Installation
INSTALLATION
PROCEDURE
1. INSTALL SECURITY COURTESY SWITCH (HOOD LOCK ASSEMBLY)
2. INSTALL HIGH PITCHED HORN ASSEMBLY
3. INSTALL RADIATOR GRILLE
4. INSTALL COOL AIR INTAKE DUCT SEAL
5. INSPECT HOOD SUB-ASSEMBLY
6. ADJUST HOOD SUB-ASSEMBLY
Engine immobilizer system
The vehicle’s keys have built-in transponder chips that prevent the engine
from starting if the key has not been previously registered in the vehicle’s on-board
computer.
Never leave the keys inside the vehicle when you leave the vehicle.
Vehicles ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY
(a) Insert the front end of the front door outside handle assembly into
the front door outside handle frame.
(b) Insert the r ...
Actuator Check
ACTUATOR CHECK
1. ACTUATOR CHECK
(a) Start the engine and warm it up.
(b) Perform the indicator check (See page
).
(c) Press the "Recirculation/Fresh" switch to perform the actuator check.
HINT:
Be sure to perform the actuator check after ...