Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR BUMPER PLATE LH
2. REMOVE REAR BUMPER PLATE RH
3. REMOVE REAR BUMPER ASSEMBLY
4. REMOVE ELECTRICAL KEY ANTENNA
(a) Disconnect the connector. |
|
(b) Remove the 2 nuts and the electrical key antenna.
NOTICE:
Be careful when removing the electrical key antenna. If the antenna is dropped, replace it with a new one.
Installation
INSTALLATION
PROCEDURE
1. INSTALL ELECTRICAL KEY ANTENNA
(a) Install the electrical key antenna with the 2 nuts. NOTICE: Be careful when installing the electrical key antenna. If the antenna is dropped, replace it with a new one. |
|
(b) Connect the connector.
2. INSTALL REAR BUMPER ASSEMBLY
3. INSTALL REAR BUMPER PLATE LH
4. INSTALL REAR BUMPER PLATE RH
Correct driving posture
Drive with a good posture as follows:
1. Sit upright and well back in the seat.
2. Adjust the position of the seat forward or backward to ensure the pedals can
be reached and easily depressed to the extent required. 3. Adjust the seatback so
that the c ...
Wheels
If a wheel is bent, cracked or heavily corroded, it should be replaced.
Otherwise, the tire may separate from the wheel or cause loss of handling control.
- Wheel selection
When replacing wheels, care should be taken to ensure that they are equivalent ...
Transmission Fluid Pressure Sensor / Switch "E" Circuit Low (P0989,P0990)
DESCRIPTION
ATF pressure switch No. 3 is installed in the lock-up solenoid ATF output passage
and is used to detect a malfunction in the lock-up solenoid.
DTC No.
DTC Detection Condition
Trouble Area
P0989
...