Toyota Venza: ECU Version Miss Match (C1288/88)

Toyota Venza Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / ECU Version Miss Match (C1288/88)

DESCRIPTION

DTC Code	DTC Detection Condition	Trouble Area
C1288/88	ECM does not match.	ECM

PROCEDURE

1.	CHECK CAN COMMUNICATION SYSTEM

(a) Check if a CAN communication system DTC is output (See page ).

Result	Proceed to
DTC is not output	A
DTC is output	B

INSPECT CAN COMMUNICATION SYSTEM

2.	PERFORM ENGINE VARIANT LEARNING

(a) Perform engine variant learning (See page ).

HINT:

Engine variant learning is automatically performed immediately after the Test Mode is entered.
If learning has not yet been performed, the ABS warning and slip indicator lights will remain on and DTC C1288/88 will be stored.

3.	RECONFIRM DTC

(a) Turn the ignition switch off.

(b) Clear the DTCs (See page ).

(d) Check if the same DTC is recorded (See page ).

Result	Proceed to
DTC (C1288/88) is not output	A
DTC (C1288/88) is output (for 2GR-FE)	B
DTC (C1288/88) is output (for 1AR-FE)	C

END

REPLACE ECM (for 2GR-FE)

REPLACE ECM (for 1AR-FE)

Brake Pedal Load Sensing Switch (C1267/67)

DESCRIPTION The brake pedal load sensing switch is turned on when the brake pedal is depressed with force exceeding a predetermined level. The skid control ECU detects if the brake pedal is depres ...

Open in Stop Light Switch Circuit (C1249/49)

DESCRIPTION The skid control ECU (housed in the actuator assembly) inputs the stop light switch signal and the condition of brake operation. The skid control ECU has an open detection circuit, whi ...

Other materials about Toyota Venza:

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the power steering system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Cold Start Idle Air Control System Performance (P050A)
MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC is stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the idl ...

One or more Power Seat Motors do not Operate
DESCRIPTION Signals are input into the position control ECU and switch assembly. The built-in ECU manages the signals received from the position control ECU and switch assembly, and operates each motor. If the position control ECU and switch assembly rece ...