DESCRIPTION
Detection Item |
Symptom |
Trouble Area |
---|---|---|
ECM Communication Stop Mode |
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
HINT:
PROCEDURE
1. |
CHECK CAN BUS WIRE FOR DISCONNECTION (ECM MAIN WIRE) |
(a) Turn the ignition switch off.
(b) for 1AR-FE engine:
(1) Disconnect the connector of the ECM. Text in Illustration
|
|
(2) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
A49-13 (CANH) - A49-5 (CANL) |
Ignition switch off |
108 to 132 Ω |
(c) for 2GR-FE engine:
(1) Disconnect the connector of the ECM. Text in Illustration
|
|
(2) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
A41-10 (CANH) - A41-11 (CANL) |
Ignition switch off |
108 to 132 Ω |
NG |
REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (ECM MAIN WIRE) |
|
2. |
CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
(a) Check for ECM Power Source Circuit (1AR-FE: See page
, 2GR-FE: See page
).
Result |
Proceed to |
---|---|
OK (for 1AR-FE engine) |
A |
OK (for 2GR-FE engine) |
B |
NG |
C |
A |
REPLACE ECM |
B |
REPLACE ECM |
C |
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) |
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
When troubleshooting a vehicle with a diagnosis system, the only difference from
the usual troubleshooting procedure is connecting the Techstream to the vehicle
and reading various data output from the vehicle's skid c ...
Lost Communication with ECM / PCM "A" (U0100,U0129)
DESCRIPTION
The combination meter assembly communicates with the ECM via the CAN communication
system (CAN No. 1 Bus).
DTC No.
DTC Detection Condition
Trouble Area
U0100
When either of the follow ...
Display does not Dim when Light Control Switch is Turned ON
PROCEDURE
1.
CHECK IMAGE QUALITY SETTING
(a) Turn the light control switch to the tail or head position.
(b) Check that the daytime screen setting on the display adjustment screen is
set to on.
Result
...