Toyota Venza manuals

Toyota Venza: Dtc Check / Clear

DTC CHECK / CLEAR

1. DTC CHECK/CLEAR (USING TECHSTREAM)

(a) CHECK DTC

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch on (IG).

(3) Read the DTC by following the prompts on the Techstream screen.

HINT:

Refer to the Techstream operator's manual for further details.

(b) CLEAR DTC

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch on (IG).

(3) Clear the DTC by following the directions on the Techstream screen.

HINT:

The Techstream has a SNAPSHOT function which records the monitored data.

Refer to the Techstream operator's manual for further details.

2. SELF-DIAGNOSTIC MODE (OPERATING IGNITION KEY CYLINDER)

(a) Switch to self-diagnostic mode.

(1) Insert the key into the ignition key cylinder and remove it.

(2) Within 5 seconds after the key is removed, insert it into the ignition key cylinder and then turn the ignition switch to ON then off once. (End in off)

(3) Within 30 seconds after turning the ignition switch off, perform the following 9 times: Turn the ignition switch to ON then off. (End in off)

HINT:

Turning the ignition switch to ON after the procedure above has been completed will end the self-diagnostic mode.

NOTICE:

If the system fails to enter self-diagnostic mode, the system will return to normal mode.

(b) Check that the system has switched to self-diagnostic mode by checking the interior light output pattern.


(c) Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern.


(d) Check the diagnostic outputs when the door control transmitter switch is held down. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer patterns.


3. SELF-DIAGNOSTIC MODE (USING TECHSTREAM)

(a) Switch to self-diagnostic mode.

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON and turn the Techstream main switch on.

HINT:

Refer to the Techstream operator's manual for further details.

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to "See page" in the ...

Other materials about Toyota Venza:

Vehicle identification
 - Vehicle identification number The vehicle identification number (VIN) is the legal identifier for your vehicle. This is the primary identification number for your Toyota. It is used in registering the ownership of your vehicle. This number is s ...

Precaution
PRECAUTION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Power back door system ...

Inspection
INSPECTION PROCEDURE 1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition ...

© 2016-2024 Copyright www.tovenza.com

0.1247