Toyota Venza: Dtc Check / Clear

Toyota Venza Service Manual / Sliding Roof / Convertible / Sliding Roof System / Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.

(e) Check the details of the DTC(s) (See page ).

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.

(e) Clear the DTC(s).

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Position Initialization Incomplete (B2343)

DESCRIPTION This DTC is output when the sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized. DTC Code DTC Detection Condition Trouble ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (a) Align the splines of the shaft and install the drive shaft assembly LH using a brass bar and a hammer. NOTICE: Set the shaft snap ring with the opening fac ...

Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR Text in Illustration *1 Component without harness connected (Engine Coolant Temperature Sensor) *2 Temperature °C (°F) *3 ...

Lost Communication with "Door Control Module A" (U0199)
DESCRIPTION DTC No. DTC Detection Condition Trouble Area U0199 No communication from the outer mirror control ECU (for front passenger side) continues. Outer mirror control ...