Toyota Venza manuals

Toyota Venza: Driving assist systems

To help enhance driving safety and performance, the following systems operate automatically in response to various driving situations.

Be aware, however, that these systems are supplementary and should not be relied upon too heavily when operating the vehicle.

 - ABS (Anti-lock Brake System)

Helps to prevent wheel lock when the brakes are applied suddenly, or if the brakes are applied while driving on a slippery road surface.

 - Brake assist

Generates an increased level of braking force after the brake pedal is depressed, when the system detects a panic stop situation.

 - VSC (Vehicle Stability Control)

Helps the driver to control skidding when swerving suddenly or turning on slippery road surfaces

 - TRAC (Traction Control)

Maintains drive power and prevent the front wheels (2WD models) or four wheels (AWD models) from spinning when starting the vehicle or accelerating on slippery roads.

 - EPS (Electric Power Steering)

Employs an electric motor to reduce the amount of effort needed to turn the steering wheel.

 - Enhanced VSC (Enhanced Vehicle Stability Control)

Provides cooperative control of the ABS, TRAC, VSC and EPS.

Helps to maintain directional stability when swerving on slippery road surfaces by controlling steering performance.

 - Hill-start assist control

 - Active Torque Control 4WD (if equipped)

Automatically switches from front-wheel drive to AWD (All- Wheel Drive) according to driving conditions, helping to ensure reliable handling and stability. Examples of conditions where the system will switch to AWD are when cornering, going uphill, starting off or accelerating, and when the road surface is slippery due to snow or rain etc.

Detection range of the sensors
1. Approximately 1.6 ft. (50 cm) 2. Approximately 4.9 ft. (150 cm) 3. Approximately 2.0 ft. (60 cm) The diagram shows the detection range of the sensors. Note that the sensors cannot detect obs ...

When the TRAC/VSC system are operating
The slip indicator light will flash while the TRAC/VSC systems are operating. ...

Other materials about Toyota Venza:

Programming HomeLink® (for U.S.A. owners)
To ensure correct programming into the HomeLink®, install a new battery in the hand-held transmitter prior to programming. Failure to install a new battery into the hand-held transmitter will affect both the range and accuracy of the HomeLink® in your ...

Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING BRAKE PEDAL ASSEMBLY (a) Install the parking brake pedal assembly with the 3 nuts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} (b) Connect t ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ...

© 2016-2024 Copyright www.tovenza.com

0.1244