DESCRIPTION
The side collision sensor RH circuit (to determine deployment of the front seat side airbag assembly RH and curtain shield airbag assembly RH) is composed of the center airbag sensor assembly, rear airbag sensor RH and side airbag sensor RH.
The side airbag sensor RH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1690/15 is stored when a malfunction is detected in the side airbag sensor RH.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B1690/15 |
|
|
WIRING DIAGRAM
PROCEDURE
1. |
CHECK SIDE AIRBAG SENSOR RH |
(a) Turn the ignition switch off. |
|
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Interchange the side airbag sensor LH with RH and connect the connectors.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the ignition switch to ON, and wait for at least 60 seconds.
(f) Clear the DTCs stored in memory (See page ).
(g) Turn the ignition switch off.
(h) Turn the ignition switch to ON, and wait for at least 60 seconds.
(i) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC B1690/15 is output. |
A |
DTC B1695/16 is output. |
B |
DTCs B1690/15 and B1695/16 are not output. |
C |
*1 |
Side Airbag Sensor LH |
*2 |
Rear Airbag Sensor RH |
HINT:
Codes other than DTCs B1690/15 and B1695/16 may be output at this time, but they are not related to this check.
A |
REPLACE CENTER AIRBAG SENSOR ASSEMBLY |
B |
REPLACE SIDE AIRBAG SENSOR RH |
C |
USE SIMULATION METHOD TO CHECK |
Headlight Relay Circuit
DESCRIPTION
The main body ECU (driver side junction block assembly) controls the headlight
relays.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection proc ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH side and RH side.
The following procedure listed below is for the LH side.
PROCEDURE
1. REMOVE FRONT WHEEL
2. REMOVE FRONT WIPER ARM HEAD CAP
3. REMOVE FRONT WI ...
Rear Left Sensor Malfunction (C1AE6)
DESCRIPTION
The No. 1 ultrasonic sensor (rear left sensor) is installed on the rear bumper.
The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor
(rear left sensor). If the No. 1 ultrasonic sensor (rear left sensor) has an o ...