DESCRIPTION
The side collision sensor LH circuit (to determine deployment of the front seat side airbag assembly LH and curtain shield airbag assembly LH) is composed of the center airbag sensor assembly, rear airbag sensor LH and side airbag sensor LH.
The side airbag sensor LH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1695/16 is stored when a malfunction is detected in the side airbag sensor LH.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B1695/16 |
|
|
WIRING DIAGRAM
PROCEDURE
1. |
CHECK SIDE AIRBAG SENSOR LH |
(a) Turn the ignition switch off. |
|
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Interchange the side airbag sensor RH with LH and connect the connectors.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the ignition switch to ON, and wait for at least 60 seconds.
(f) Clear the DTCs stored in memory (See page ).
(g) Turn the ignition switch off.
(h) Turn the ignition switch to ON, and wait for at least 60 seconds.
(i) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC B1695/16 is output. |
A |
DTC B1690/15 is output. |
B |
DTCs B1690/15 and B1695/16 are not output. |
C |
*1 |
Side Airbag Sensor RH |
*2 |
Rear Airbag Sensor LH |
HINT:
Codes other than DTCs B1690/15 and B1695/16 may be output at this time, but they are not related to this check.
A |
REPLACE CENTER AIRBAG SENSOR ASSEMBLY |
B |
REPLACE SIDE AIRBAG SENSOR LH |
C |
USE SIMULATION METHOD TO CHECK |
System Description
SYSTEM DESCRIPTION
1. WIRELESS DOOR LOCK CONTROL SYSTEM
The wireless door lock control system functions to lock and unlock all the doors
from a distance. The system is controlled by a door control transmitter which sends
radio waves to the door control r ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSFER ASSEMBLY
(a) Install the transfer assembly to the automatic transaxle assembly
with 2 new bolts and the 6 nuts.
Torque:
69 N·m {700 kgf·cm, 51 ft·lbf}
NOTICE:
Install the ...
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) When troubleshooting On-Board Diagnostic (OBD II) vehicles, the vehicle must
be connected to the OBD II scan tool (complying with SAE J1987). Various data output
from the vehicle TCM can then be read.
(b) OBD II regul ...