Toyota Venza: Door Mirror Foot Light

Toyota Venza Service Manual / Lighting (ext) / Door Mirror Foot Light

Components

COMPONENTS

ILLUSTRATION

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.

PROCEDURE

1. REMOVE OUTER MIRROR

2. REMOVE OUTER MIRROR LIGHT ASSEMBLY

(a) Disengage the 2 claws and guide from the outer rear view mirror assembly.

(b) Disconnect the connector and remove the outer mirror light assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT OUTER MIRROR LIGHT ASSEMBLY LH

(a) Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2.

(b) Check that the outer mirror foot light comes on.

OK:

The light comes on.

Text in Illustration

*1	Component without harness connected (Outer Mirror Light Assembly LH)

If the result is not as specified, replace the outer mirror light assembly LH.

2. INSPECT OUTER MIRROR LIGHT ASSEMBLY RH

(a) Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2.

(b) Check that the outer mirror foot light comes on.

OK:

The light comes on.

Text in Illustration

*1	Component without harness connected (Outer Mirror Light Assembly RH)

If the result is not as specified, replace the outer mirror light assembly RH.

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.

PROCEDURE

1. INSTALL OUTER MIRROR LIGHT ASSEMBLY

(a) Connect the connector.

(b) Engage the guide and 2 claws to install the outer mirror light assembly.

2. INSTALL OUTER MIRROR

Automatic Light Control Sensor

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE DEFROSTER NOZZLE GARNISH 2. REMOVE AUTOMATIC LIGHT CONTROL SENSOR (a) Disengage the 2 claws and remov ...

Fog Light Assembly

Components COMPONENTS ILLUSTRATION Disassembly DISASSEMBLY PROCEDURE 1. REMOVE FOG LIGHT BULB (a) Turn the fog light bulb in the direction indicated by the arrow shown in t ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR BUMPER ASSEMBLY (See page ) 2. REMOVE ULTRASONIC SENSOR CLIP (a) Disconnect the connector. Text in Illustration *A LH Side *B ...

Door Side Airbag Sensor LH Malfunction (B1695/16)
DESCRIPTION The side collision sensor LH circuit (to determine deployment of the front seat side airbag assembly LH and curtain shield airbag assembly LH) is composed of the center airbag sensor assembly, rear airbag sensor LH and side airbag sensor LH. ...

System Diagram
SYSTEM DIAGRAM Communication Method Transmitting ECU Receiver Signal Communication Method Main body ECU (Driver Side Junction Block Assembly) Power back door ECU (Power back door motor ...