Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE COURTESY LIGHT ASSEMBLY
(a) Using a screwdriver wrapped with protective tape, disengage the claw. Text in Illustration
|
|
(b) Disconnect the connector and remove the courtesy light assembly.
Inspection
INSPECTION
PROCEDURE
1. INSPECT COURTESY LIGHT ASSEMBLY
(a) Connect a positive (+) lead from the battery to terminal 2 and a negative (-) lead to terminal 1. |
|
(b) Check that the courtesy light comes on.
OK:
Courtesy light comes on.
Text in Illustration
*1 |
Component without harness connected (Courtesy Light Assembly) |
If the result is not as specified, replace the bulb or courtesy light assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL COURTESY LIGHT ASSEMBLY
(a) Connect the connector.
(b) Engage the claw to install the courtesy light assembly. |
|
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful bec ...
Room Light
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE SPOT LIGHT ASSEMBLY
(a) Using a screwdriver with its tip wrapped with protective tape, disengage
the 8 claws to remove the 2 spot light lenses.
Text in Illust ...
Removal
REMOVAL
PROCEDURE
1. REMOVE PARKING BRAKE PEDAL ASSEMBLY
HINT:
Refer to the instructions for Removal of the parking brake pedal assembly (See
page ).
2. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY
(a) Remove the clip.
...