Toyota Venza: Door Control Receiver

Back Door Lock

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY 2. REMOVE BACK DOOR LOCK ASSEMBLY (a) Disconnect the connector. ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY (a) Install the rear center seat outer belt assembly with the bolt and nut. Torque: Bolt : 7.5 N·m {77 kgf·cm, 66 in·lbf} Nut : 42 N·m {428 kgf·cm, ...

On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the steering pad. PROCEDURE 1. INSPECT STEERING PAD (Vehicle not Involved in Collision) (a) Perform a diagnostic system check (S ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE RADIATOR RESERVE TANK ASSEMBLY (a) Remove t ...