Toyota Venza: Disposal

Toyota Venza Service Manual / Rear Suspension / Rear Shock Absorber / Disposal

DISPOSAL

PROCEDURE

1. DISPOSE OF REAR SHOCK ABSORBER

(a) Fully extend the shock absorber piston rod.

(b) Using a drill, make a hole in area B shown in the illustration to discharge the gas inside.

Length (A):

25 mm (0.984 in.)

Length (B):

25 mm (0.984 in.)

NOTICE:

Be careful when drilling because shards of metal may fly about. Always use proper safety equipment.

HINT:

The gas is colorless, odorless and non-poisonous.

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. SECURE REAR SHOCK ABSO ...

Rear Stabilizer Bar(for 2wd)

Components COMPONENTS ILLUSTRATION ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE REAR WHEELS 2. REMOVE REAR STABILIZER LINK ASSEMBLY LH (a) Remove the nut and separate t ...

Other materials about Toyota Venza:

Navigation Antenna
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY HINT: Refer to the procedure up to Remove Instrument Panel Safety Pad Assembly (See page ). 2. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT ...

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

SD Card Communication Malfunction (B158C)
DESCRIPTION The navigation receiver assembly stores this DTC when the SD card (disc player disc) cannot be mounted when inserted into the SD card (disc player disc) slot. DTC No. DTC Detection Condition Trouble Area ...