Toyota Venza: Disassembly

Toyota Venza Service Manual / U660e Automatic Transmission / Transaxle / Valve Body Assembly(when Using The Engine Support Bridge) / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE TRANSMISSION WIRE

2. REMOVE ATF TEMPERATURE SENSOR ASSEMBLY

(a) Remove the 4 bolts, ATF temperature sensor assembly and clamp from the valve body assembly.

Text in Illustration

Clamp

(b) Remove the O-ring from the ATF temperature sensor assembly.

Text in Illustration

O-ring

3. REMOVE SHIFT SOLENOID VALVE SL

(a) Remove the shift solenoid valve SL from the valve body assembly.

4. REMOVE SHIFT SOLENOID VALVE SLT

(a) Remove the lock plate and shift solenoid valve SLT from the valve body assembly.

Text in Illustration

*1	Lock Plate
*2	Solenoid Valve SLT
*3	Solenoid Valve SLU

5. REMOVE SHIFT SOLENOID VALVE SLU

(a) Remove the shift solenoid valve SLU from the valve body assembly.

6. REMOVE SHIFT SOLENOID VALVE SL2

(a) Remove the bolt, lock plate and shift solenoid valve SL2 from the valve body assembly.

Text in Illustration

*1	Lock Plate
*2	Solenoid Valve SL2
*3	Solenoid Valve SL1

7. REMOVE SHIFT SOLENOID VALVE SL1

(a) Remove the shift solenoid valve SL1 from the valve body assembly.

8. REMOVE SHIFT SOLENOID VALVE SL3

(a) Remove the bolt, lock plate and shift solenoid valve SL3 from the valve body assembly.

Text in Illustration

*1	Lock Plate
*2	Solenoid Valve SL3

9. REMOVE SHIFT SOLENOID VALVE SL4

(a) Remove the bolt, lock plate and shift solenoid valve SL4 from the valve body assembly.

Text in Illustration

*1	Lock Plate
*2	Solenoid Valve SL4

Removal

REMOVAL PROCEDURE 1. DRAIN AUTOMATIC TRANSAXLE FLUID 2. REMOVE FRONT FRAME ASSEMBLY See page 3. SUPPORT ENGINE ASSEMBLY 4. REMOVE BELT 5. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEM ...

Inspection

INSPECTION PROCEDURE 1. INSPECT SHIFT SOLENOID VALVE SL (a) Measure the resistance according to the value(s) in the table below. Text in Illustration *1 ...

Other materials about Toyota Venza:

HD Radio Tuner Malfunction (B1551,B15A0,B15AD,B15B0,B15B3,B15B4,B15B7)
DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation receiver assembly. DTC No. DTC Detection Condition Trouble Area B1551 When any of the following conditions is met: ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT) (w/ POWER BACK DOOR SYSTEM) (a) Disconnect the L20 power back door ECU connector. (b) Measure the voltage and resistance according to the value(s) in the table below. ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 2GR-FE) HINT: Refer to the procedure up to Re ...