Toyota Venza: Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY
.gif)
2. REMOVE PARKING BRAKE SWITCH ASSEMBLY
3. REMOVE PARKING PEDAL PAD
(a) Remove the parking pedal pad from the parking brake pedal assembly.
Removal
REMOVAL
PROCEDURE
1. REMOVE YAW RATE AND ACCELERATION SENSOR
HINT:
Refer to the instructions for Removal of the yaw rate and acceleration sensor
(See page ).
2. REMOVE REAR NO. 2 AIR DUCT
...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL PARKING PEDAL PAD
(a) Install the parking pedal pad to the parking brake pedal assembly.
2. INSTALL PARKING BRAKE SWITCH ASSEMBLY
3. INSTALL NO. 1 PARKING BRAKE ...
Other materials about Toyota Venza:
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful bec ...
Precaution
PRECAUTION
1. BEFORE WORKING ON FUEL SYSTEM
(a) When disconnecting a fuel line, fuel will splash. So observe the following
precautions:
(1) Do not smoke or work near fire when handling the fuel system.
(2) Keep gasoline away from rubber or leather parts. ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
NOTICE:
Turn the ignition switch off before removing any parts.
HINT:
If no malfunction is found when inspecting parts, inspect the skid control
ECU and ground points for poor connections.
If a trouble code is ...
0.1591