DISASSEMBLY
PROCEDURE
1. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof)
2. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof)
3. REMOVE VANITY LIGHT ASSEMBLY
(a) Remove the vanity light assembly (See page ).
HINT:
Use the same procedure for the RH side and the LH side.
4. REMOVE FRONT SIDE RAIL SPACER LH (w/o Sliding Roof)
(a) Remove the front side rail spacer LH.
5. REMOVE FRONT SIDE RAIL SPACER RH (w/o Sliding Roof)
HINT:
Use the same procedure for the RH side and the LH side.
6. REMOVE NO. 3 ROOF SILENCER PAD (w/o Sliding Roof)
(a) Remove the 3 No. 3 roof silencer pads.
7. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)
(a) Remove the 2 No. 2 roof silencer pads.
8. REMOVE NO. 1 ROOF WIRE (w/o Sliding Roof)
(a) Remove the adhesive tape.
Text in Illustration
*1 |
Adhesive Tape |
- |
- |
(b) Turn the visor connectors counterclockwise approximately 90° and separate the connectors.
(c) Remove the No. 1 roof wire.
9. REMOVE NO. 1 ROOF WIRE (w/ Sliding Roof)
(a) Remove the adhesive tape.
(b) Turn the visor connectors counterclockwise approximately 90° and separate the connectors.
(c) Remove the No. 1 roof wire.
Text in Illustration
*1 |
Adhesive Tape |
- |
- |
10. REMOVE NO. 14 ROOF SILENCER PAD
(a) Remove the No. 14 roof silencer pad.
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE BOOSTER ASSEMBLY
(a) Airtightness check
(1) Start the engine and stop it after 1 or 2 minutes. Slowly depress
the brake pedal several times.
HINT:
If the pedal can be depressed to the ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
(e) Check the details of the DTC(s) ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the 2C, 2F and 2K main body ECU (driver side junction block assembly)
connectors.
(b) Measure the voltage and resistance according to the value(s) in the table ...