Toyota Venza: Disassembly

Toyota Venza Service Manual / Interior Panels / Trim / Instrument Panel Safety Pad / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

(a) Remove the 2 screws <E> or <F> and remove the No. 1 side defroster nozzle duct.

2. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

(a) Remove the 2 screws <E> or <F> and remove the No. 2 side defroster nozzle duct.

3. REMOVE DEFROSTER NOZZLE ASSEMBLY

(a) Remove the 4 screws <E> or <F> and remove the defroster nozzle assembly.

4. REMOVE HEATER TO REGISTER DUCT

(a) Remove the 7 screws <E> or <F> and remove the heater to register duct.

5. REMOVE NO. 1 ANTENNA CORD SUB-ASSEMBLY

6. REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)

7. REMOVE NO. 3 INSTRUMENT PANEL WIRE

(a) Disengage the 4 clamps and remove the No. 3 instrument panel wire.

8. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

9. REMOVE GLOVE BOX LIGHT ASSEMBLY

(a) Disengage the 2 claws and remove the glove box light assembly.

10. REMOVE NO. 1 INSTRUMENT PANEL PIN

(a) Remove the 2 screws <E> or <F> and the 2 No. 1 instrument panel pins.

Removal

REMOVAL PROCEDURE 1. PRECAUTION (See page ) 2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 1 INSTRUMENT PANEL PIN (a) Install the 2 No. 1 instrument panel pins with the 2 screws <E> or <F>. ...

Other materials about Toyota Venza:

Precaution
PRECAUTION 1. PRECAUTION FOR DISCONNECTING THE BATTERY CABLE NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected. System Name See Procedure ...

Seat heaters
1. For driver’s seat 2. For front passenger’s seat 3. On The indicator light comes on. 4. Adjusts the seat temperature The further you turn the dial upward, the warmer the seat becomes. - The seat heaters can be used when ►Vehicles wit ...

Precaution
PRECAUTION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Back Door Closer System ...