Toyota Venza: Disassembly

Toyota Venza Service Manual / Interior Panels / Trim / Front Console Box / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE NO. 1 CONSOLE BOX CARPET

(a) Remove the No. 1 console box carpet.

2. REMOVE INSTRUMENT PANEL CUP HOLDER DAMPER

(a) Pull the instrument panel cup holder damper in the direction indicated by the arrow to remove the instrument panel cup holder damper.

3. REMOVE CONSOLE BOX POCKET

(a) Pull the console box pocket in the direction indicated by the arrow to disengage the 2 guides and remove the console box pocket.

4. REMOVE FRONT CONSOLE BOX COVER

(a) Disengage the clamp.

(b) Remove the 3 screws.

5. REMOVE STEREO JACK ADAPTER ASSEMBLY

6. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY

(a) Slide the rear console upper panel sub-assembly in the direction indicated by the arrow and remove the rear console upper panel sub-assembly.

7. REMOVE NO. 2 CONSOLE BOX DUCT

(a) Remove the 2 screws and the No. 2 console box duct.

8. REMOVE CONSOLE MOUNTING RETAINER ASSEMBLY

(a) Using a moulding remover, disengage the 5 claws and remove the console mounting retainer assembly.

9. REMOVE CONSOLE BOX WIRE

(a) Disconnect the connectors to remove the console box wire.

10. REMOVE CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY

11. REMOVE CENTER POWER POINT SOCKET ASSEMBLY

12. REMOVE CENTER POWER OUTLET SOCKET COVER

13. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY

(a) Disengage the 4 clips and remove the rear console end panel sub-assembly.

14. REMOVE REAR CONSOLE ARMREST ASSEMBLY

(a) Using a screwdriver, remove the 2 E-rings.

NOTICE:

Be careful not to allow the E-rings to pop out when removing them.

(b) Using a screwdriver, pull out the box door hinge shafts.

Text in Illustration

*1	Protective Tape

HINT:

Tape the screwdriver tip before use.
The illustration is for the LH side.
Use the same procedure for the RH side and LH side.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Removal

REMOVAL PROCEDURE 1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) 2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) 3. REMOVE NO. 2 CONSOLE BOX CARPET ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT TRANSMISSION OIL CLEANER MAGNET (a) Use the removed transmission oil cleaner magnets to collect any steel chips. Examine the chips and particles in the automatic transaxle oil pan sub-assembly and on the tr ...

Mass Air Flow Meter
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT NOTICE: Perform the mass air flow meter inspection according to the procedure below. Only replace the mass air flow meter when t ...

Interior Light Circuit
DESCRIPTION The illuminated entry system controls the roof console box assembly, step or spot light assembly and transponder key amplifier*1. HINT: *1: w/o Smart Key System WIRING DIAGRAM PROCEDURE 1. PERFORM ACTIVE TEST USING ...