DISASSEMBLY
PROCEDURE
1. REMOVE MAGNETIC CLUTCH ASSEMBLY
(a) Place the compressor and magnetic clutch in a vise. |
|
(b) Using SST, hold the magnetic clutch hub.
SST: 09985-00270
(c) Remove the bolt, magnetic clutch hub, and magnetic clutch washers.
HINT:
There is no set number of magnetic clutch washers because they are used for adjustment.
(d) Using a snap ring expander, remove the snap ring and then remove the magnetic clutch rotor. NOTICE: Take care not to damage the seal cover of the bearing when removing the snap ring. |
|
(e) Disconnect the connector. |
|
(f) Disengage the clamp.
(g) Remove the screw and the bracket.
(h) Using a snap ring expander, remove the snap ring and magnetic clutch stator. NOTICE: Take care not to damage the seal cover of the bearing when removing the snap ring. |
|
Installing child restraints using a seat belt (child restraint lock function
belt)
- Rear-facing -- Infant seat/convertible seat
Place the child restraint system on the rear seat facing the rear of the vehicle.
Run the seat belt through the child restraint system and insert the plate into
the buckle. Make sure that the belt is ...
Terminals Of Ecu
TERMINALS OF ECU
1. TERMINALS OF ECU
Text in Illustration
*1
Component without harness connected
(Brake Actuator (Skid Control ECU))
Terminal No. (Symbol)
Terminal Description
1 (GND ...
Unmatched Key Code (B2795)
DESCRIPTION
This DTC is stored when a key with a key code that has not been registered in
the ECU is inserted into the ignition key cylinder.
DTC No.
DTC Detection Condition
Trouble Area
B2795
Ke ...