DISASSEMBLY
PROCEDURE
1. REMOVE SLIDING ROOF HOUSING CENTER FRAME
(a) Remove the 2 nuts and sliding roof housing center frame. |
|
2. REMOVE NO. 4 SUNSHADE TRIM SUB-ASSEMBLY
(a) Remove the screw and rear sliding roof sunshade stopper LH. HINT: Use the same procedure for the RH side and the LH side. |
|
(b) Remove the screw and center sliding roof sunshade stopper LH. HINT: Use the same procedure for the RH side and the LH side. |
|
(c) Remove the screw and front sliding roof sunshade stopper LH. HINT: Use the same procedure for the RH side and the LH side. |
|
(d) Slide and remove the No. 4 sunshade trim sub-assembly. |
|
3. REMOVE NO. 3 SUNSHADE TRIM SUB-ASSEMBLY
(a) Slide and remove the No. 3 sunshade trim sub-assembly. |
|
4. REMOVE NO. 2 SUNSHADE TRIM SUB-ASSEMBLY
(a) Slide and remove the No. 2 sunshade trim sub-assembly. |
|
5. REMOVE NO. 1 SUNSHADE TRIM SUB-ASSEMBLY
(a) Slide and remove the No. 1 sunshade trim sub-assembly. |
|
Lost Communication with ECM / PCM "A" (U0100,U0129)
DESCRIPTION
The combination meter assembly communicates with the ECM via the CAN communication
system (CAN No. 1 Bus).
DTC No.
DTC Detection Condition
Trouble Area
U0100
When either of the follow ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Read the DTCs by following the directions on the Techstream screen.
HINT:
Refer to the Techstream operator's m ...
Traffic Information is not Displayed
PROCEDURE
1.
CHECK DISPLAY
(a) Check which communication is not being used for displaying traffic information.
HINT:
Display of traffic information received via HD traffic is given priority while
in an "HD Radio" ...