Toyota Venza: Disassembly

Toyota Venza Service Manual / Mirror (ext) / Outer Rear View Mirror / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE OUTER MIRROR

2. REMOVE OUTER MIRROR LIGHT ASSEMBLY

3. REMOVE OUTER MIRROR COVER

4. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY

Removal

REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make ...

Inspection

INSPECTION PROCEDURE 1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH (a) Check the operation of the mirror surface. (1) Disconnect the outer rear view mirror assembly RH connector. ...

Other materials about Toyota Venza:

Internal Control Module EEPROM Error (P062F)
DESCRIPTION The ECM monitors its internal operation and it stores this DTC when it detects an internal malfunction. DTC No. DTC Detection Condition Trouble Area P062F An ECM internal error (EEPRO ...

Adjustment
ADJUSTMENT PROCEDURE 1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Remove the transmission control shaft lever. HINT: See the steps from "Remove Cool Air Intake Duct Seal" through "Remove Park/Neutral Position Switch Assembly" ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) The transponder key ECU assembly controls the vehicle's immobiliser system functions. Immobiliser system data and Diagnostic Trouble Code (DTC) can be read through the vehicle's Data Link Connector 3 (DLC3). I ...