Toyota Venza manuals

Toyota Venza: Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE NO. 2 HEADLIGHT BULB (for Halogen Headlight)

(a) Turn the No. 2 headlight bulb in the direction indicated by the arrow shown in the illustration, and remove it.

NOTICE:

Do not touch the bulb glass.


2. REMOVE LIGHT CONTROL ECU (for HID Headlight)

(a) Turn the light control ECU in the direction indicated by the arrow shown in the illustration, and disconnect it.

NOTICE:

  • Do not apply excessive force using a tool.
  • Do not damage the O-ring or allow it to become contaminated with foreign matter. If the O-ring is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the light control ECU.

(b) Turn the socket of the light control ECU in the direction indicated by the arrow shown in the illustration, and remove it.

NOTICE:

Do not pull the light control ECU with the socket connected.


3. REMOVE DISCHARGE HEADLIGHT BULB (for HID Headlight)

(a) Release the set spring as shown in the illustration and remove the discharge headlight bulb.

NOTICE:

Do not touch the bulb glass.


4. REMOVE NO. 1 HEADLIGHT BULB (for Halogen Headlight)

(a) Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration, and remove it.

NOTICE:

Do not touch the bulb glass.


5. REMOVE FRONT TURN SIGNAL LIGHT BULB

(a) for Halogen Headlight:

(1) Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.


(b) for HID Headlight:

(1) Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.


(c) Remove the front turn signal light bulb from the front turn signal light socket.

6. REMOVE FRONT SIDE MARKER LIGHT BULB

(a) Turn the front side marker light socket with the front side marker light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.


(b) Remove the front side marker light bulb from the front side marker light socket.

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. PRECAUTION (for HID Headligh ...

Other materials about Toyota Venza:

Sliding Roof ECU Communication Stop (B1273)
DESCRIPTION This DTC is stored when LIN communication between the sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (driver side junction block assembly) stops for more than 10 seconds. DTC No. DTC Detection ...

Inspection
INSPECTION PROCEDURE 1. INSPECT ATF TEMPERATURE SENSOR ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Sp ...

System Description
SYSTEM DESCRIPTION 1. WIRELESS DOOR LOCK CONTROL SYSTEM The wireless door lock control system can be used to lock and unlock all doors from a distance. The system is controlled by a door control transmitter which sends radio waves to the door control rec ...

© 2016-2024 Copyright www.tovenza.com

0.149