Toyota Venza: Disassembly

Toyota Venza Service Manual / Exterior Panels / Trim / Rear Bumper / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE ULTRASONIC SENSOR CLIP (w/ Intuitive Parking Assist System)

2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)

3. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)

4. REMOVE REAR BUMPER WIRE (w/ Intuitive Parking Assist System)

5. REMOVE REFLEX REFLECTOR ASSEMBLY LH

(a) Remove the screw.

(b) Disengage the guide and remove the reflex reflector assembly LH.

6. REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:

Use the same procedure for the RH side and LH side.

7. REMOVE REAR BUMPER SPOILER LH (for 1AR-FE)

(a) Remove the outside moulding retainer and clip.

Text in Illustration

*1	Outside Moulding Retainer

(b) Remove the screw and rear bumper spoiler LH.

8. REMOVE REAR BUMPER SIDE RETAINER LH

(a) Remove the screw.

(b) Disengage the 2 claws and remove the rear bumper side retainer LH.

9. REMOVE REAR BUMPER SIDE RETAINER RH

HINT:

Use the same procedure for the RH side and LH side.

10. REMOVE NO. 2 REAR BUMPER SIDE SUPPORT LH

(a) Remove the screw.

(b) Disengage the 2 claws and remove the No. 2 rear bumper side support LH.

11. REMOVE NO. 2 REAR BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure for the RH side and LH side.

12. REMOVE REAR BUMPER ENERGY ABSORBER

(a) Disengage the 2 guides and remove the rear bumper energy absorber.

13. REMOVE NO. 1 REAR BUMPER REINFORCEMENT

(a) Remove the 6 nuts and No. 1 rear bumper reinforcement.

Removal

REMOVAL PROCEDURE 1. REMOVE REAR BUMPER PLATE LH (a) Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws and remove the rear bumper plate LH. Text ...

Installation

INSTALLATION PROCEDURE 1. INSTALL REAR BUMPER ASSEMBLY (a) w/ Intuitive Parking Assist System: (1) Connect each connector. (b) Engage the 6 claws and install the rear bumper assembly a ...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure listed is for the LH side. PROCEDURE 1. REMOVE FRONT WHEEL 2. REMOVE FRONT AXLE SHAFT NUT 3. SEPARATE FRONT SPEED SENS ...

Parking Brake Switch Circuit
DESCRIPTION This circuit is from the parking brake switch assembly to the radio and display receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK BRAKE WARNING LIGHT (a) Check that the brake warning light comes on when t ...

GCWR, TWR and Unbraked TWR
Confirm that the gross trailer weight, gross combination weight, gross vehicle weight, gross axle weight and tongue weight are all within the limits. - GCWR* and TWR* ► Vehicles without towing package ► Vehicles with towing package ...