Toyota Venza: Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE HOOD TO RADIATOR SUPPORT SEAL
|
(a) Using a clip remover, disengage the 10 clips and remove the hood to radiator support seal. |
|
2. REMOVE HOOD INSULATOR
|
(a) Using a clip remover, remove the 10 clips. |
|
(b) Disengage the 2 claws and remove the hood insulator.
3. REMOVE FRONT WASHER NOZZLE SUB-ASSEMBLY
.gif)
4. DISCONNECT WASHER HOSE ASSEMBLY
|
(a) Using a clip remover, disengage the 5 clips and disconnect the washer hose assembly. |
|
Hood
...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT HOOD SUB-ASSEMBLY
(a) Check that the clearance measurements of areas *1 through *4 are within each
standard range.
Standard Clearance
Area ...
Other materials about Toyota Venza:
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 2 COOLING FAN MOTOR
(a) Install the No. 2 cooling fan motor with the 3 screws.
Torque:
w/o Towing package :
2.6 N·m {26 kgf·cm, 23 in·lbf}
w/ Towing package :
3.9 N·m {40 kgf·cm, 35 in ...
Receiver Error (C2176/76)
DESCRIPTION
The signals are transmitted to the tire pressure warning antenna and receiver
on the body as radio waves and then sent to the tire pressure warning ECU.
DTC No.
DTC Detection Condition
Trouble Area
...
Customize Parameters
CUSTOMIZE PARAMETERS
HINT:
The following items can be customized.
NOTICE:
After confirming whether the items requested by the customer are applicable
or not for customization, perform customizing operations.
Be sure to record the current se ...
0.1289