Toyota Venza: Disassembly

Toyota Venza Service Manual / Steering Gear / Linkage / Steering Gear(for 1ar-fe 2wd) / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE STEERING RACK BOOT CLIP (for LH Side)

(a) Using pliers, remove the steering rack boot clip.

2. REMOVE STEERING RACK BOOT CLIP (for RH Side)

HINT:

Perform the same procedure as for the LH side.

3. REMOVE NO. 2 STEERING RACK BOOT CLAMP

(a) Using a screwdriver, remove the No. 2 steering rack boot clamp.

NOTICE:

Be careful not to damage the steering rack boot.

4. REMOVE NO. 1 STEERING RACK BOOT CLAMP

HINT:

Perform the same procedure as for the No. 2 steering rack boot clamp.

5. REMOVE NO. 2 STEERING RACK BOOT

6. REMOVE NO. 1 STEERING RACK BOOT

Removal

REMOVAL CAUTION / NOTICE / HINT NOTICE: When disconnecting the steering intermediate shaft assembly and pinion shaft of the steering gear assembly, be sure to place matchmarks before servicing. ...

Inspection

INSPECTION PROCEDURE 1. INSPECT TIE ROD ASSEMBLY LH 2. INSPECT TIE ROD ASSEMBLY RH HINT: Perform the same procedure as for the LH side. 3. INSPECT TOTAL PRELOAD ...

Other materials about Toyota Venza:

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the engine immobiliser system. *: Using the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: When disconnecting the steering intermediate shaft assembly and pinion shaft of steering gear assembly, be sure to place matchmarks before servicing. PROCEDURE 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 2. SECUR ...

Installation
INSTALLATION PROCEDURE 1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY (a) Engage the claw to install the windshield wiper switch assembly as shown in the illustration. (b) Connect the 2 connectors. ...