DISASSEMBLY
PROCEDURE
1. REMOVE GENERATOR REAR END COVER
(a) Remove the 3 nuts and generator rear end cover. |
|
2. REMOVE TERMINAL INSULATOR
(a) Remove the terminal insulator from the generator coil. |
|
3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
(a) Remove the 2 screws and brush holder from the generator coil. |
|
4. REMOVE GENERATOR COIL ASSEMBLY
(a) Remove the 4 bolts. |
|
(b) Using SST, remove the generator coil assembly. Text in Illustration
SST: 09950-40011 09951-04020 09952-04010 09953-04020 09954-04010 09955-04071 09957-04010 09958-04011 |
|
(c) Remove the generator washer. |
|
5. REMOVE GENERATOR CLUTCH PULLEY
(a) Using a screwdriver, remove the generator pulley cap. NOTICE: Do not reuse the generator pulley cap. |
|
(b) Mount the generator drive end frame in a vise tightly.
(c) Confirm SST (A) and (B) shown in the illustration. Text in Illustration
SST: 09820-63021 |
|
(d) Place the rotor shaft end into SST (A). Text in Illustration
|
|
(e) Fit SST (B) to the clutch pulley. Text in Illustration
|
|
(f) Loosen the pulley by turning SST (B) in the direction shown in the illustration. Text in Illustration
NOTICE:
|
|
(g) Remove SST from the generator assembly.
(h) Remove the clutch pulley from the rotor shaft.
6. REMOVE GENERATOR ROTOR ASSEMBLY
(a) Remove the generator rotor assembly. |
|
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column ...
Throttle / Pedal Position Sensor / Switch "D" Circuit Range / Performance (P2121)
DESCRIPTION
Refer to DTC P2120 (See page ).
HINT:
This DTC relates to the accelerator pedal sensor assembly.
DTC No.
DTC Detection Condition
Trouble Area
P2121
Either of following conditions 1 o ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
7 (SS1) ...