DISASSEMBLY
PROCEDURE
1. REMOVE GENERATOR PULLEY CAP
(a) Using a screwdriver, puncture the center of the generator pulley cap and pry it off. NOTICE: Do not reuse the generator pulley cap. |
|
2. REMOVE GENERATOR PULLEY WITH CLUTCH
(a) Mount the generator in a vise. Text in Illustration
|
|
(b) Install SST (A) and (B) to the pulley as shown in the illustration.
SST: 09820-63021
(c) Use a wrench to hold SST (A), and turn SST (B) counterclockwise to loosen the generator pulley. Text in Illustration
NOTICE:
|
|
(d) Remove the generator pulley.
3. REMOVE GENERATOR REAR END COVER
(a) Place the generator on the generator pulley.
(b) Remove the 3 nuts and generator rear end cover. |
|
(c) Remove the terminal insulator. |
|
4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
(a) Remove the 2 screws and generator brush holder. |
|
5. REMOVE GENERATOR COIL ASSEMBLY
(a) Remove the 4 bolts. |
|
(b) Using SST, remove the generator coil. SST: 09950-40011 09951-04020 09952-04010 09953-04020 09954-04010 09955-04071 09957-04010 |
|
6. REMOVE GENERATOR ROTOR ASSEMBLY
(a) Remove the generator washer. |
|
(b) Remove the generator rotor assembly. |
|
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE TAIL AND STOP LIGHT BULB
(a) Turn the tail and stop light bulb and the rear combination light
socket and wire in the direction indicated by the arrow shown in the illustration,
and remove them as a unit.
...
How To Proceed With Troubleshooting
HOW TO PROCEED WITH TROUBLESHOOTING
1. OPERATION FLOW
HINT:
Perform troubleshooting in accordance with the procedure below. The following
is an outline of basic troubleshooting procedure. Confirm the troubleshooting procedure
for the circuit you are wor ...
System Description
SYSTEM DESCRIPTION
1. POWER MIRROR CONTROL SYSTEM DESCRIPTION
(a) This system has the following functions: power retract mirror function*,
reverse shift-linked function, electrical remote control function, memory function
and mirror heater function.
...