Toyota Venza: Differential System

Toyota Venza Service Manual / Axle And Differential / Differential System

Precaution

PRECAUTION

Before disassembly, clean the outside of the differential assembly and remove any sand or mud to prevent it from entering the inside of the assembly during disassembly and installation.
When removing an installed part made of light alloy such as the differential side bearing retainer, tap it off with a brass bar and a hammer. Do not attempt to pry it off with a screwdriver.
Always arrange disassembled parts in order and protect them from dust.
Before installation, thoroughly clean and dry each part and then apply Toyota Genuine Differential gear oil LT SAE 75W-85 API GL-5 or equivalent to them. Do not use alkaline cleaner for aluminum or rubber parts and rear differential case bolts. Also, do not clean rubber parts such as oil seals with non-residue solvent.
Coat sliding surfaces and rotating parts with Toyota Genuine Differential gear oil LT SAE 75W-85 API GL-5 or equivalent.
When holding a part in a vise, be sure to place aluminum plates between the part and vise. Do not put it directly in the vise.
Do not damage the sealing surfaces of the case. Such damage may cause oil leakage.
Do not add oil within 1 hour or allow rapid acceleration or deceleration within 12 hours of installing sealed parts.
Damage to surfaces in contact with an oil seal or gasket may cause oil leakage.
When press-fitting an oil seal, do not damage the oil seal lip or outside periphery.
When replacing a bearing, replace the inner and outer races as a set.
When replacing a hypoid gear, replace the ring gear and drive pinion as a set.
Replace any damaged or deformed plate washers.
Before applying seal packing, completely remove any old seal packing remaining on the components using a non-residue solvent.
New bearings are coated with anti-rust oil. If using new bearings, do not wash it off.

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Differential System

Symptom	Suspected Area	See page
Noise in rear differential	Oil (Level too low or wrong grade)
	Ring gear or drive pinion (Worn or chipped)
	Backlash adjustment (Defective)
	Preload adjustment (Defective)
	Tooth contact between ring gear and drive pinion (Defective)
	Bearing (Worn)
Oil leaks from rear differential	Oil (Level too high or wrong grade)
	Carrier oil seal (Worn or damaged)
	Side gear shaft oil seal (Worn or damaged)
	Seal packing (Damaged)

Differential Oil

Replacement REPLACEMENT CAUTION / NOTICE / HINT HINT: Stop the vehicle on a level surface. PROCEDURE 1. DRAIN DIFFERENTIAL OIL (a) Using a 10 mm hexagon wrench, remove the rear dif ...

Front Axle Hub

...

Other materials about Toyota Venza:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the tab ...

Child restraint systems with a top tether strap
Secure the child restraint using a seat belt or lower anchors, and do the following. ► Outside Adjust the head restraint to the upmost position. ► Center Lower the head restraint to the lowest position. Open the anchor bracket cover, ...

A/F Sensor Slow Response - Rich to Lean Bank 1 Sensor 1 (P014C,P014D,P015A,P015B)
DESCRIPTION HINT: Refer to DTC P2195 (See page ). DTC No. DTC Detection Condition Trouble Area P014C The "Rich to Lean response rate deterioration level*" value is standard or less ...