Toyota Venza: Differential Case

Reassembly

REASSEMBLY PROCEDURE 1. BEARING POSITION (a) Check each bearing position and installation direction. Mark Front Race Diameter Inside / Outside mm (in.) Thru ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SUB-ASSEMBLY (a) Using a precision straightedge and feeler gauge, measure the warpage of the contact surfaces where the cylinder head contacts the cylinder block and manifold. Maximum Warpage: ...

Precaution
PRECAUTION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Back Door Closer System ...

Brake Warning Light does not Come ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. WIRING DIAGRAM Refer to Brake Warning Light Remains ON (See page ). PROCEDURE 1. CHECK CAN COMMUNICATION SYSTEM (a) Check if a ...