DIAGNOSTIC TROUBLE CODE CHART
ACTIVE TORQUE CONTROL 4WD SYSTEM
DTC Code |
Detection Item |
Trouble Area |
See page |
---|---|---|---|
C1241/94 |
Low Power Supply Voltage |
1. Battery 2. ECU-IG1 fuse 3. Wire harness and connector (IG1 circuit, GND circuit) 4. Brake control system 5. CAN communication system 6. AWD control ECU |
|
C1245/93 |
Malfunction in Deceleration Sensor |
1. Brake control system (deceleration sensor circuit) 2. CAN communication system 3. AWD control ECU |
|
C1280/82 |
Engine Circuit Malfunction |
1. SFI system 2. AWD control ECU |
|
C1296/96 |
ABS Malfunction |
1. Brake control system (speed sensor circuit) 2. CAN communication system 3. AWD control ECU |
|
C1298/98 |
Linear Solenoid Circuit |
1. 4WD fuse 2. Wire harness and connector 3. Electromagnetic control coupling 4. AWD control ECU |
|
C1299/99 |
Cancellation of 4WD Control |
1. Tire size 2. AWD control ECU |
|
U0073/86 |
Control Module Communication Bus OFF |
1. CAN communication system |
|
U0100/85 |
Lost Communication with ECM / PCM "A" |
1. CAN communication system |
|
U0129/83 |
Lost Communication with Brake System Control Module |
1. CAN communication system |
|
Moon roof
Use the overhead switches to open, close, and tilt the moon roof up and down.
- Opening and closing
1. Open
The moon roof stops slightly before the fully open position to reduce wind noise.
Move the switch backward again to fully open.
2. Close ( ...
ECU Power Source Circuit
DESCRIPTION
This circuit provides power for main body ECU (driver side junction block assembly)
operation.
WIRING DIAGRAM
PROCEDURE
1.
CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU (POWER SOURCE))
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT GENERATOR CLUTCH PULLEY
(a) Hold the generator rotor using SST, and turn the clutch pulley clockwise
to check that the outer ring locks.
SST: 09820-63021
Text in Illustration
*1
...