DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is stored during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.
Certification ECU (Smart Key ECU Assembly)
DTC Code |
Detection Item |
Trouble Area |
See page |
---|---|---|---|
B27A1 |
Open in Driver Side Electrical Antenna Circuit |
1. Front door outside handle assembly (for driver side) 2. Certification ECU (smart key ECU assembly) 3. Wire harness or connector |
|
B27A2 |
Open in Front Passenger Side Electrical Antenna Circuit |
1. Front door outside handle assembly (for front passenger side) 2. Certification ECU (smart key ECU assembly) 3. Wire harness or connector |
|
B27A5 |
Open in Front Floor Electrical Key Oscillator Circuit |
1. Indoor electrical key oscillator (for front floor) 2. Certification ECU (smart key ECU assembly) 3. Wire harness or connector |
|
B27A6 |
Open in Rear Floor Electrical Key Oscillator Circuit |
1. Indoor electrical key oscillator (for center floor) 2. Certification ECU (smart key ECU assembly) 3. Wire harness or connector |
|
B27A7 |
Open in Inside Luggage Compartment Electrical Key Oscillator Circuit |
1. Indoor electrical key oscillator (for rear floor) 2. Certification ECU (smart key ECU assembly) 3. Wire harness or connector |
|
B27A8 |
Open in Outside Luggage Compartment Electrical Key Antenna Circuit |
1. Outside electrical key oscillator (for rear side) 2. Certification ECU (smart key ECU assembly) 3. Wire harness or connector |
|
Speed Sensor(when Using The Engine Support Bridge)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE TRANSMISSION VALVE BODY ASSEMBLY
See page
2. REMOVE SPEED SENSOR
(a) Disconnect the speed sensor connector.
(b) Remove the 2 bolts and speed sensor from the tra ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
If there are no DTCs output and the problem still occurs, check the circuits
for each problem symptom in the order given in the following table and proceed to
the relevant troubleshooting page.
NOTICE:
When replacing the brake act ...
Power Source Mode does not Change to ON (IG)
DESCRIPTION
When the engine switch is pushed with the electrical key in the cabin, the power
management control ECU receives signals to change the power source mode.
HINT:
To allow use of the Techstream to inspect the push-button start function when
the ...