Toyota Venza: Diagnostic Trouble Code Chart

Toyota Venza Service Manual / Door Lock / Wireless Door Lock Control System(w/o Smart Key System) / Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

HINT:

If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to "See page" in the DTC chart.

Inspect the fuses and relays before troubleshooting the areas shown in the table below.

Wireless Door Lock Control System

DTC Code	Detection Item	Trouble Area	See page
B1242	Wireless Door Lock Tuner Circuit Malfunction	1. Wire harness or connector 2. Door control receiver 3. Main body ECU (driver side junction block assembly)

DTC Code

Detection Item

Trouble Area

See page

B1242

Wireless Door Lock Tuner Circuit Malfunction

1. Wire harness or connector

2. Door control receiver

3. Main body ECU (driver side junction block assembly)

Dtc Check / Clear

DTC CHECK / CLEAR 1. DTC CHECK/CLEAR (USING TECHSTREAM) (a) CHECK DTC (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch on (IG). (3) Read the DTC by following the prompts on th ...

Wireless Door Lock Tuner Circuit Malfunction (B1242)

DESCRIPTION The door control receiver receives signals from the transmitter and sends these signals to the main body ECU (driver side junction block assembly). DTC No. DTC De ...

Other materials about Toyota Venza:

Steering Angle Sensor Circuit Malfunction (C1231/31)
DESCRIPTION The steering angle sensor signal is sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it will be detected by the steering angle sensor zero point malfunction diagnostic ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: Make sure to select FACE mode before disconnecting the cable from the negative (-) battery terminal. PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBL ...