Toyota Venza manuals

Toyota Venza: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

HINT:

If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to "See page" in the DTC chart.

  • Inspect the fuses and relays before troubleshooting the areas shown in the table below.
Wireless Door Lock Control System

DTC Code

Detection Item

Trouble Area

See page

B1242

Wireless Door Lock Tuner Circuit Malfunction

1. Wire harness or connector

2. Door control receiver

3. Certification ECU (Smart key ECU assembly)


Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Wireless Door Lock Tuner Circuit Malfunction (B1242)
DESCRIPTION The door control receiver is used to receive electrical waves relating to the entry functions of the smart key system. The certification ECU (smart key ECU assembly) decodes the reque ...

Other materials about Toyota Venza:

Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a new or known good one and check that the malfunction disappears. OK: Malfunction disappears. OK END NG REPLACE ...

Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) bat ...

Compressor Solenoid Circuit (B1451/51)
DESCRIPTION In this circuit, the A/C compressor receives a refrigerant compression demand signal from the A/C amplifier. Based on this signal, the A/C compressor changes the amount of compressor output. DTC No. DTC Detection Conditio ...

© 2016-2024 Copyright www.tovenza.com

0.136