Toyota Venza manuals

Toyota Venza: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

If a trouble code is displayed during the DTC check, check the trouble areas listed for that code in the table below and proceed to the appropriate page.

Cruise Control System

DTC Code

Detection Item

Trouble Area

See page

P0500

Vehicle Speed Sensor Malfunction

- Vehicle speed sensor signal circuit

- Vehicle speed sensors

- Combination meter assembly

- ECM


P0503

Vehicle Speed Sensor "A" Intermittent / Erratic / High

- Vehicle speed sensors

- Vehicle speed sensor signal circuit

- Combination meter assembly

- ECM


P0571

Brake Switch "A" Circuit

- Stop light switch assembly

- Stop light switch circuit

- ECM


P0575

Cruise Control Input Circuit

ECM


Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Vehicle Speed Sensor "A" Intermittent / Erratic / High (P0503)
DESCRIPTION If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while the cruise control is in operation, the ECM det ...

Other materials about Toyota Venza:

Engine
General Maintenance GENERAL MAINTENANCE CAUTION / NOTICE / HINT HINT: Perform these procedures after the engine has cooled down. PROCEDURE 1. INSPECT DRIVE BELT Engine Type See Procedure 2GR-FE See pag ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR WHEELS 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (a) Remove the center exhaust pipe assembly. HINT: Refer to the instructions for Removal of the exhaust pipe (See page for 2GR-FE, for 1AR-FE). 3. REMOVE LOWER NO. 1 EXH ...

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line ECM Navigation Receiver Assembly*1 Radio and Display Receiver Assembly*2 Reverse sig ...

© 2016-2024 Copyright www.tovenza.com

0.1459