Toyota Venza: Diagnosis System

Toyota Venza Service Manual / Lighting (ext) / Lighting System / Diagnosis System

DIAGNOSIS SYSTEM

1. DESCRIPTION

(a) Lighting system data and the Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and to repair.

2. CHECK DLC3

(a) Check the DLC3 (See page ).

3. INSPECT BATTERY VOLTAGE

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) (a) Disconnect the 2A and 2F main body ECU (driver side junction block assembly) connectors. (b) Measure the voltag ...

Dtc Check / Clear

DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired sy ...

Other materials about Toyota Venza:

Engine Stall History (P1603,P1605)
DESCRIPTION P1603 After starting the engine, this DTC is stored when the engine stops without the ignition switch being operated. Using the Techstream, the conditions present when the DTC was stored can be confirmed by referring to the freeze frame data ...

Installation
INSTALLATION PROCEDURE 1. INSTALL MANUAL VALVE (a) Coat the manual valve with ATF and install it to the transmission valve body assembly. 2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY (a) Coat th ...

Room Temperature Sensor Circuit (B1411/11)
DESCRIPTION The room temperature sensor is installed in the instrument panel. It detects the cabin temperature to control the air conditioning AUTO mode. The resistance of the room temperature sensor changes in accordance with the cabin temperature. As ...