DIAGNOSIS SYSTEM
1. CHECK DLC3
(a) Check the DLC3 (See page ).
2. FUNCTION OF P/S WARNING LIGHT
(a) When a malfunction is detected in the power steering system, the P/S warning light on the accessory meter comes on to inform the driver of the malfunction.
HINT:
When power assist is stopped or reduced, the P/S warning light comes on.
Power assist is stopped:
Power assist is reduced:
3. CHECK P/S WARNING LIGHT
(a) Check that the P/S warning light comes on when the ignition switch is turned to ON and goes off in approximately 3 seconds.
(b) If the warning light remains on, refer to PS Warning Light Remains ON (See page ).
Speed Signal Malfunction (B15C2)
DESCRIPTION
The navigation receiver assembly receives a vehicle speed signal from the combination
meter assembly and information from the navigation antenna assembly, and then adjusts
the vehicle position.
The navigation receiver assembly stores this DTC ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
When installing new name plates and emblem, heat the vehicle body, name plates
and emblem using a heat light.
Heating Temperature
Item
Temperature
Vehicle Body
40 to ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY
(a) Set the No. 1 center support bearing on the intermediate shaft as
shown in the illustration.
NOTICE:
Make sure to install the bearing in the correct position.
...