Toyota Venza manuals

Toyota Venza: Diagnosis Circuit

DESCRIPTION

This circuit is used to read the DTCs that are output from the transponder key ECU assembly with the Techstream.

WIRING DIAGRAM


CAUTION / NOTICE / HINT

NOTICE:

If the transponder key ECU assembly is replaced, register the key and ECU communication ID (See page ).


PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (DLC3 - TRANSPONDER KEY ECU AND BODY GROUND)

(a) Disconnect the transponder key ECU assembly connector.


(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

D22-9 (D) - D1-7 (SIL)

Always

Below 1 Ω

D1-4 (CG) - Body ground

Always

Below 1 Ω

D22-9 (D) - Body ground

Always

10 kΩ or higher

D1-7 (SIL)- Body ground

Always

10 kΩ or higher

Text in Illustration

*1

Front view of wire harness connector

(to Transponder Key ECU Assembly)

*2

Front view of wire harness connector

(to DLC3)


OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY


NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

ECU Power Source Circuit
DESCRIPTION This circuit provides power to operate the transponder key ECU assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the transponder key ECU assembly is replaced, register the ...

Entry Lock And Unlock Switch
...

Other materials about Toyota Venza:

Freeze Frame Data
FREEZE FRAME DATA 1. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. (e) Select a DTC to ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because in ...

Window Defogger Wire
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. CHECK REAR WINDOW DEFOGGER SYSTEM OPERATION (a) When the ignition switch is turned to ON and the rear window defogger switch is pressed, check that the rear window defogger system operates. 2. I ...

© 2016-2024 Copyright www.tovenza.com

0.1706