DESCRIPTION
This DTC is stored when the submersion circuit monitor inside the power management control ECU detects a large amount of water.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B2277 |
The submersion circuit monitor inside the power management control ECU detects a large amount of water. |
Power management control ECU |
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
CHECK FOR DTC |
(a) Clear the DTC (See page ).
(b) Turn the engine switch on (IG).
(c) After 330 seconds have elapsed, check if the DTC has been set again.
OK:
DTC B2277 is not output.
HINT:
If there are any signs that water was present, before replacing the power source control ECU, take measures to prevent any further water entry.
OK |
USE SIMULATION METHOD TO CHECK |
NG |
REPLACE POWER MANAGEMENT CONTROL ECU |
System Too Lean (Bank 1) (P0171,P0172)
DESCRIPTION
The fuel trim is related to the feedback compensation value, not to the basic
injection duration. The fuel trim consists of both the short-term and long-term
fuel trims.
The short-term fuel trim is fuel compensation that is used to constantly ...
Speedometer Malfunction
DESCRIPTION
The meter CPU receives vehicle speed signals from the skid control ECU via the
CAN communication system (CAN No. 1 Bus). The speed sensor detects the wheel speed
and sends the appropriate signals to the skid control ECU. The skid control ECU
...
The distance display and buzzer
When a sensor detects an obstacle, the direction of and the approximate distance
to the obstacle are displayed and the buzzer sounds.
- Corner sensor operation and distance to an obstacle
The system operates when the vehicle approaches within the fol ...