DEFINITION OF TERMS
Term |
Definition |
---|---|
Monitor description |
Description of what the TCM monitors and how it detects malfunctions (monitoring purpose and its details). |
Related DTCs |
Diagnostic code |
Typical enabling condition |
Preconditions that allow the TCM to detect malfunctions. With all preconditions satisfied, the TCM sets the DTC when the monitored value(s) exceeds the malfunction threshold(s). |
Sequence of operation |
The priority order that is applied to monitoring, if multiple sensors and components are used to detect the malfunction. While another sensor is being monitored, the next sensor or component will not be monitored until the previous monitoring has concluded. |
Required sensor/components |
The sensors and components that are used by the TCM to detect malfunctions. |
Frequency of operation |
The number of times that the TCM checks for malfunctions per driving cycle. "Once per driving cycle" means that the TCM detects malfunction only one time during a single driving cycle. "Continuous" means that the TCM detects malfunction every time when the enabling conditions are met. |
Duration |
The minimum time that the TCM must sense a continuous deviation in the monitored value(s) before setting a DTC. This timing begins after the "typical enabling conditions" are met. |
Malfunction thresholds |
Beyond this value, the TCM will conclude that there is a malfunction and set a DTC. |
MIL operation |
MIL illumination timing after a defect is detected. "Immediately" means that the TCM illuminates MIL the instant the TCM determines that there is a malfunction. "2 driving cycle" means that the TCM illuminates MIL if the same malfunction is detected again in the 2nd driving cycle. |
Component operating range |
Normal operation range of sensors and solenoids under normal driving conditions. Use these ranges as a reference. They cannot be used to judge if a sensor or solenoid is defective. |
If your vehicle overheats
The following may indicate that your vehicle is overheating.
• The engine coolant temperature gauge reaches the maximum, or a loss of
engine power is experienced. (For example, the vehicle speed does not increase.)
• Steam comes out from under the hood ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
(a) Remove the 2 screws <E> or <F> and remove the No. 1 side defroster
nozzle duct.
2. REMOVE NO. 2 SIDE DEFROSTER NO ...
Disposal
DISPOSAL
CAUTION / NOTICE / HINT
CAUTION:
Before performing pre-disposal deployment of any SRS component, review and closely
follow all applicable environmental and hazardous material regulations. Pre-disposal
deployment may be considered hazardous mate ...