Toyota Venza: Data Signal Circuit between Radio Receiver and Extension Module

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Data Signal Circuit between Radio Receiver and Extension Module

DESCRIPTION

The stereo component tuner assembly sends the image data signal to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

PROCEDURE

1.	CHECK NAVIGATION WIRE

(a) Remove the navigation wire (See page ).

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
V9-1 (USV4) - V6-1 (USV4)	Always	Below 1 Ω
V9-2 (US4-) - V6-2 (US4-)	Always	Below 1 Ω
V9-3 (US4+) - V6-3 (US4+)	Always	Below 1 Ω
V9-4 (UGD4) - V6-4 (UGD4)	Always	Below 1 Ω
V9-5 (USG4) - V6-5 (USG4)	Always	Below 1 Ω
V9-1 (USV4) - Body ground	Always	10 kΩ or higher
V9-2 (US4-) - Body ground	Always	10 kΩ or higher
V9-3 (US4+) - Body ground	Always	10 kΩ or higher
V9-4 (UGD4) - Body ground	Always	10 kΩ or higher
V9-5 (USG4) - Body ground	Always	10 kΩ or higher

Text in Illustration

Front view of navigation wire connector

(to Radio and Display Receiver Assembly)

Front view of navigation wire connector

(to Stereo Component Tuner Assembly)

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

REPLACE NAVIGATION WIRE

Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit. WIRING DIAGRAM ...

Reverse Signal Circuit

DESCRIPTION The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly. WIRING DIAGRAM PROCEDURE 1. CHECK BACK-UP L ...

Other materials about Toyota Venza:

Driver Side Door Entry Lock Function does not Operate
DESCRIPTION If the driver door entry unlock function operates normally, but its entry lock function does not, this means that the request code from the driver door is being output normally. In this case, a malfunction in the lock sensor circuit (from the ...

Tire Pressure Warning Ecu
Components COMPONENTS ILLUSTRATION ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT NOTICE: Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for re-registration of ...

IG Power Source Circuit
DESCRIPTION The main power source is supplied to the A/C amplifier when the ignition switch is ON. The power source is used for operating the A/C amplifier and servo motor, etc. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for cir ...