Toyota Venza: Customize Parameters

Toyota Venza Service Manual / Theft Deterrent / Keyless Entry / Theft Deterrent System(w/o Smart Key System) / Customize Parameters

CUSTOMIZE PARAMETERS

HINT:

The following items can be customized.

NOTICE:

After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
Be sure to record the current settings before customization.
When troubleshooting, make sure that the item in question is not set to OFF as a result of customization (Example: For the system, "the wireless function does not operate", first check that the wireless function is not set to OFF, then perform troubleshooting).

1. CUSTOMIZE

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Customize Setting /

(e) Select the setting by referring to the table below.

Security

Display (Item)	Default	Content	Setting
Warning by Horn	ON	Function that allows the vehicle horn and theft deterrent horn to be used as warning devices	ON or OFF
Passive Mode (Security System)	OFF	Passive Mode is a function that switches the theft deterrent system from the arming preparation state to the armed state 30 seconds after the key is removed from the key cylinder and all doors, engine hood and back door are closed, even if the doors are not locked by wireless or door key lock operation. In Passive Mode, if the following operations are not performed within 14 seconds after a door is opened during armed state, the theft deterrent system will judge that condition as a theft and switch to the alarm sounding state. Unlock any door by key or wireless operation Turn the ignition switch to ON	ON or OFF
Entry Delay	14 s	Function that changes entry delay time (time before warning starts) for Passive Mode	0 s, 14 s or 30 s

How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use this procedure to troubleshoot the theft deterrent system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHO ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DOOR LOCK ASSEMBLY NOTICE: When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one. Do not allow grease or dust to adhere to the door ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH (See page ) 2. REMOVE FRONT DOOR SCUFF PLATE LH 3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH 5. REMOVE REAR DOOR SCUFF PLATE LH 6. REMOVE REAR ...

Engine compartment
► 2GR-FE engine 1. Engine coolant reservoir 2. Engine oil filler cap 3. Engine oil level dipstick 4. Brake fluid reservoir 5. Battery 6. Fuse box 7. Electric cooling fans 8. Condenser 9. Radiator 10.Washer fluid tank ► 1AR-FE engine ...