CUSTOMIZE PARAMETERS
1. CUSTOMIZE FUNCTION WITH TECHSTREAM
NOTICE:
HINT:
The following items can be customized using the Techstream.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Utility / Customize Setting.
(e) Select the setting by referring to the table below.
Combination Meter
Tester Display |
Default |
Content |
Setting |
---|---|---|---|
Driver Side Seatbelt Warning Buzzer |
ON |
Function to sound the seat belt warning buzzer |
ON/OFF |
Front Passenger Side Seatbelt Warning Buzzer |
ON |
Function to sound the seat belt warning buzzer |
ON/OFF |
HINT:
This setting is only valid for the buzzer which sounds at 20 km/h (13 mph) or more.
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the rear
airbag sensor.
PROCEDURE
1. INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic sys ...