CUSTOMIZE PARAMETERS
1. CUSTOMIZE METER / GAUGE SYSTEM
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Warning.
(5) Select the setting by referring to the table below.
NOTICE:
Tester Display |
Default |
Content |
Setting |
---|---|---|---|
Key Remind Volume |
Large |
Function to change the volume of the key reminder buzzer. |
Large, Medium, Small |
Key Remind Sound |
Normal |
Function to change the frequency of the key reminder buzzer. |
Normal, Slow, Fast |
Driver Side Seatbelt Warning Buzzer*1 |
ON |
Function to turn on/off the seat belt warning buzzer. |
ON or OFF |
Front Passenger Side Seatbelt Warning Buzzer*1 |
ON |
Function to turn on/off the seat belt warning buzzer. |
ON or OFF |
Removal
REMOVAL
PROCEDURE
1. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 1AR-FE)
2. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 2GR-FE)
3. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 1AR-FE)
4. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 2GR-FE)
5. REMOVE PROPELLER ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY
(a) Align the matchmarks on the steering intermediate shaft assembly
and the steering column assembly.
Text in Illustration
*1
Matc ...
Terminals Of Ecu
TERMINALS OF ECU
1. REAR TELEVISION CAMERA ASSEMBLY
(a) Disconnect the R21 rear television camera assembly connector.
(b) Measure the voltage on the wire harness side connector according to the value(s)
in the table below.
Terminal No. (Symb ...